EDGE PULLS
Edge pulls are designed for installation on ¾” thick doors. Custom sizing is available for other door thicknesses.
Edge pulls should be installed by a professional tradesperson. A recessed groove is required to be cut in the door to allow the handle to sit flush with the door edge. We suggest cutting recessed grooves after receiving the product. As a natural material, leather thicknesses can vary slightly.
Handles are supplied with pre-cut fixing holes. Fastening screws are supplied. For best results, handles should first be installed with a standard #6 square head screw prior to installing the slotted screws provided.
STRAP PULLS
Our Strap Pulls are supplied with pre-cut fixing holes and mounting hardware. Our Hardware is designed for use on 3/4” thick doors. Please contact us for custom sizing.
As a natural material, leather thicknesses can vary slightly.
LOOP PULLS
Our Loop Pulls are supplied with pre-cut fixing holes and mounting hardware. Our Hardware is designed for use on 3/4” thick doors. Please contact us for custom sizing.
As a natural material, leather thicknesses can vary slightly.
BAR PULLS
Our Bar Pulls are supplied with mounting hardware designed for use on 3/4” thick doors. Please contact us for custom sizing and hardware.
Please note that Bar Pull standoffs are shipped with a short screw to maintain a pressure fitting. These screws should be left in place until installation. The longer screws provided should be used for installation. We suggest using a screwdriver to tighten the screws rather than a drill.